Base Soap Pump Holder - Chrome

Base Soap pump holder is beautiful, decorative and practical with a stylish design from Beslag Design. The design emphasizes its simplicity, the straight back plate together with the curved finish on the curved surface creates a harmony and shows off the soft details. Create a whole in the bathroom by mixing products from the Base series. Base Soap pump holder is available in three designs; stainless steel, matte black and chrome.

Base Soap pump holder fits perfectly with soap bottles from, for example, L:A Bruket. The diameter of the product's hole is 28mm, it is a standard measure that enables the hanging of an infinite number of different soap bottles. - you set the boundaries!

Base soap pump holder is mounted with 3M tape, which means you do not have to drill holes where you want to place the soap pump.

Installation Instructions:

1. Thoroughly clean the surface with a 3M surface cleaning sachet, click here to find the product.
2. Remove the protective film.
3. Apply the product by pressing it against the substrate for 10 seconds.
4. For optimal adhesion allow the adhesive to cure 24 hours before the product is loaded.

Cleaning: Use a clean, damp cloth when cleaning the product.

NOTE! Attached to durable smooth surfaces such as tiles, lacquered or veneered board materials, etc. It is not appropriate to attach the products to uneven/rough surfaces where the tape does not get full contact or surfaces that can screw up such as bathroom wallpaper. We do not recommend mounting the product over the grout as this affects the adhesion of the 3M tape. On newly tiled walls, it is important that the surface is thoroughly cleaned so that no grout adhesive remains on the mounting surface.


 

Show more

Show less

Available varieties:

/bilder/artiklar/liten/606080-41_S.jpg?m=1628684244

/bilder/artiklar/liten/606081-41_S.jpg?m=1628684313

Show moreShow less

• Specifications

• Diameter Ø:	28 mm
  Width:	50 mm
  Depth:	68 mm
  Height:	152 mm
  Material:	Stainless Steel
  Finish:	Chrome
  Style:	Modern
  Brand:	Beslag Design
• Reviews
• Care & maintenance

• Attached to durable smooth surfaces such as tiles, lacquered or veneered board materials, etc. It is not appropriate to attach the products to uneven/rough surfaces where the tape does not get full contact or surfaces that can screw up such as bathroom wallpaper. We do not recommend mounting the product over the grout as this affects the adhesion of the 3M tape. On newly tiled walls, it is important that the surface is thoroughly cleaned so that no grout adhesive remains on the mounting surface.  

  Thoroughly clean the surface before mounting so that it is free of oil and dirt, avoid cleaning agents that contain oil. Feel free to buy our surface cleaning napkin, to make sure that the surface is properly clean during installation. Let the product sit on the selected surface for at least 24 hours before you start to use the product. 

  Installation Instructions:
  

  1. Thoroughly clean the surface with a 3M surface cleaning sachet, click here to find the product. 
  2. Remove the protective film. 
  3. Apply the product by pressing it against the substrate for 10 seconds. 
  4. For optimal adhesion allow the adhesive to cure 24 hours before the product is loaded.  

  
  When it's time to clean the product, we recommend that you use a clean, damp, wrung-out cloth. Depending on the material, the product may be damaged by cleaning agents and the surface may change, therefore we recommend that you use lukewarm water.